(7) Check the rest of the gear components such as bearings and bushings symmetry, durability and lubrication and so on.
(8) Install the new belt on the pulley, or not to pry too much force.
(9) to tighten the gear center distance, until the belt tension gauge to detect until the proper tension. Hand turn a few laps driving wheel, re-test tension.
(10) Tighten the motor mounting bolts to correct torque. As the transmission distance in the center of the operation will result in any change in poor belt performance, it is important to ensure that all transmission components have been tightened.
(11) starter and observe the belt performance, to see whether any abnormal vibration, listen for unusual noises. It is best to turn off the machine, check the bearings and motor status; if feels too hot, too tight or the bearing may be asymmetrical belt, or lubrication is not correct.

belt maintenance

1. fold belt should not be a sharp twist and bend, minimum bending diameter of belt shown in Figure 2, Table 2
   (2) in storage and transportation process, avoid direct sunlight, rain and snow soaked shower; prevent acid, alkali, organic solvents, water vapor and other substances that affect product performance contacts;
   (3) at room temperature storage, the general temperature of-20oC-50oC; and at least one meter away from the heat source.
   (4) during storage to prevent too much to bear the weight of the deformation may not be stacked off pressure not to take directly into the ground, should be on the shelf with hanging or flat land on the shelves.
   (5) wheels finished in a dry and ventilated environment, storage and transport, should be finished pulley anti-rust treatment;
   (6) should be added with a transmission shield, and to ensure ventilation and sewage.